Crusher wear parts foundry produced wear parts, such as the thing called jaw plate for crusher, can be regarded as the jaw crusher's 'teeth', you think about it, just like we usually eat to use teeth to bite and crush food, this jaw plate is used to directly squeeze and crush large pieces of material. This jaw plate is used to squeeze and crush large pieces of material directly. There are also primary gyratory crusher is also crushing operations in the large, handling the material to unambiguous, they are also crushing operations can not be ignored in the existence of.
In addition to the 'teeth' jaw, there are many other wear parts in the crusher. For example, the hammer head in the hammer crusher is like a fast rotating 'sledgehammer', constantly striking and crushing materials. This hammer head, it must be particularly hard, otherwise it will bend or break when it touches something hard, how can it work? Moreover, it must have a certain toughness and impact resistance, or turn so fast, all of a sudden broken. The impact plate and liner inside the impact crusher are like 'shields', which are specially used to withstand the impact and abrasion when the material bounces back. Think about it, after the material is broken by the hammer or jaw, it will bounce around, if there is no protection from these 'shields', then the inside of the crusher will be easily worn out. The moving cone liner and fixed cone liner inside the crusher are like two 'grinding discs', crushing materials into smaller particles by squeezing and grinding. These two 'grinding discs' ah, have to be particularly wear-resistant to do, or grinding a few times on the flat or bad, then how to continue to break the material? Therefore, they are made of high manganese steel, alloy steel, high chromium cast iron, these high-quality wear-resistant materials.
